IKEA VALGRUNDAD Mode D'emploi page 19

ENGLISH
Problem
There is too much condensed
water on the rear wall of the
refrigerator.
refrigerator.
The door does not close
completely.
Malfunction alarm
If the appliance malfunctions, the LED indicators
fault and the buzzer will sound. To switch the
control panel.
• and Temperature sensor failure
of the refrigerator chamber
• and Temperature sensor failure
of the freezer chamber
• and
Defrosting sensor failure of
the freezer chamber
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
The drain hole at the back of the
appliance is clogged.
Food products prevent water from
The door is not closed well.
The appliance tilts forward.
The drip pan cracks.
The defrost water drain is clogged.
The shelves are out of position.
The door gaskets are dirty.
The appliance is not level.
1
button on the
Possible Cause
• and
• and
temperature sensor
If your appliance still is not working
properly after making the above checks,
contact the Authorised Service Centre. You
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to the
separate Assembly Instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
Solution
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Clean the drain hole with a piece
of wire.
Make sure that food products do
not touch the rear plate.
Refer to "Closing the door", or
refer to the troubleshooting item
below ("The door does not close
completely").
Tilt the appliance slightly backward
(a quarter-inch lower in the back).
Refer to the separate Assembly
Instructions for appliance level
adjustment.
Contact Authorised Service Centre
listed at the end of this manual.
Clean the drain hole with a piece
of wire.
Make sure the shelves are in
correct position. Refer to "Movable
shelves".
Clean the door gaskets. Refer to
"Care and cleaning".
Make sure the appliances
is installed in level. Refer to
"Levelling feet", or the separate
Assembly Instructions.
Communication failure
Failure of ambient
19