Fault Finding - Electrolux B3000-40 Dossier Technique

Fault fi nding
5. THE MACHINE WILL NOT START, CHECK THAT:
1
- The machine is plugged in.
- The electrical power supply to the socket is correct.
- The operator has pressed the two START buttons simultaneously
(see §1.1 - case of standard model)
- The green button is held down.
- If the luminous indicator lights up, unplug the machine and
wait a short while for the motor to cool down. (see §1.1)
5. ABNORMAL NOISE:
2
• Stop and unplug the appliance.
• Whenever it is used, check the condition of:
- the casing, (there should be no cracks)
- the equipment used (whisk properly engaged, blade tightened,
etc)
5.3 IMMERSION OF THE DEVICE
If the device is accidentally immersed while running:
- DO NOT ATTEMPT TO GET IT OUT.
- DO NOT TOUCH THE CONTAINER
5.4 ACCIDENTAL DROP
• With the machine unplugged:
- Check the condition of the casings (no cracks and splinters).
Maintenance
6.1 MECHANICAL PARTS
• The Mixer - Whisks only require a minimum amount of mainte-
nance (the motor and the mechanical part bearings are greased
for life).
Oils and grease suitable for use with foodstuffs are to be used
if the mechanisms need to be lubricated.
• Whenever using the appliance (see §5.2):
- The play at the end of the Mixer shaft.
- The sharpness of the Mixer blade.
- The whisk casing for leaks.
- The whisk attachment system.
• To gain access to the inside of the motor unit, proceed
as follows:
- Unplug the machine.
- Remove the corrugated belt item 12 (use a screwdriver as a
lever).
- Remove the 3 M4x16 screws item 11 and remove the clamp
10 and the end cover 9.
If the device stops while running and the luminous
indicator lights up :
- unplug it and leave to cool down so that the thermal
trip can reset.
If problems persist, contact the service department of your
local dealer.
- operation of the assembly
- If there is any vibration during operation: play in the shaft,
deterioration of ball bearings or shaft out of true
If the problem persists contact your supplier' s service department.
- IMMEDIATELY UNPLUG FROM THE POWER SUPPLY.
- Warn the service department or your supplier.
- Check there are no suspicious noises by shaking the appliance.
In case of any doubt, contact the service department or your
supplier.
- Remove screw PT 40x20 located beneath the upper handle
item A and remove the upper cap item 2. Be careful not to
lose buttons S2.
- Remove the caps item 15.
- Remove the 7 screws item 13.
- Place the machine horizontally and separate the casing 14.(see
exploded view «unit».)
To refi t: proceed in reverse order.
• To gain access to the inside of the whisk unit, proceed as follows
(see whisk unit exploded diagram):
- Remove the whisks 18 by pulling fi rmly on them.
- Remove the 4 caps item 10 using a screwdriver.
- Unscrew the 4 screws item 11.
- Separate the assembly S3 and the casing item 17, taking care
to keep the casing item 17 as shown in the exploded diagram
so as not to lose the grease inside.
To refi t, proceed in reverse order.
5
B3000 GB 11 2015