Vetus SENSORD Manuel D'utilisation Et Instructions D'installation page 44

• Delete value 0.0 using the backspace func-
tion () and enter the height of the tank.
For example, '45' (cm).
This value must now be saved in the mem-
ory.
• Select Enter ( ) and press the

1x.
Tank calibration
Tank type
Tank volume
Tank depth
20% tot. depth
40% tot. depth
60% tot. depth
80% tot. depth
Exit
• Return to the menu 'Tank settings' by us-
ing the /
'Exit' and pressing
• Return to the 'Configuration menu' by us-
ing the /
'Exit' and pressing
44
090430.01
key
V-shape
123.0 l
45.0 cm
n.a.
n.a.
n.a.
n.a.
keys to navigate to
.
keys to navigate to
.
• Connect the next sensor; the name of the
sensor that has just been connected (Ve-
tus) will be displayed after a brief interval.
Configuration menu
Tank
Drinking water
Display settings
Exit
Select the sensor that has just been con-
nected using the
press 2x. The keyboard and the
name of the tank will then be displayed
again.
Repeat steps B and C for each following sen-
sor.
For a tank with an irregular shape the vol-
umes at 20, 40, 60 and 80% tot. height must
be entered after this.
This done in the same way as entering the
tank volume and tank height.
Setting the alarms is described in Chapter
'Operating' paragraph 2.4.7.
Ultrasonic tank management system
Vetus
/ keys and