Appendix: Wireless Remote Accessory Instructions - Champion RANGE AND TARGET WHEELYBIRD 2.0 Mode D'emploi

XI. Appendix: Wireless Remote Accessory Instructions
WARNING: TO AVOID SERIOUS INJURY
OR PROPERTY DAMAGE, THOROUGHLY
READ INSTRUCTIONS BEFORE USING.
Features of the Champion
Release system include:
• Battery powered hand-held remote, high
impact plastic case
• Long transmission range
• Single Release system that will work with
multiple Receiver units
• User settable delay from 0-15 seconds
• Quick and easy installation
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC
Rules.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended operation as described
in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user 's body or when set to lower
output power if such function is available.
Industry Canada Statement
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement:
This device complies with the Industry Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended operation
as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user's body or if the
device is set to a lower output power if such function is available.
Wireless Remote
®
FCC ID:2ALBZTZWR923 / IC:22547-TZWR923
23