Champion RANGE AND TARGET WHEELYBIRD 2.0 Mode D'emploi page 17

Adjustments to the limit switch are made by loosening the two mounting screws and moving
the switch slightly (small movements will make a big difference):
1. Pivot the switch slightly towards the rear of the trap to make the arm stop further away
from the edge of the main body.
2. Pivot the switch slightly towards the front of the trap to make the arm stop closer to the
edge of the main body.
3. Re-tighten the mounting screws after adjusting the switch.
4. Adjust switch so that a target drops onto the throwing arm as the arm is cocking. With
the on/off/safe release switch set to "on", the tip of the arm should stop within 2.5" to 4.5"
from the edge of the top plate of the trap. The opening in the sliding plate should line
up with the opening in the top plate and allow a target to drop.
WARNING: ADJUSTING THE ARM TO STOP AT A POINT TOO FAR AWAY FROM THE
TRAP BODY CAN RESULT IN A DELAYED RELEASE OR IMPROPER LOADING AND
TARGETS BREAKING WHICH COULD RESULT IN PERSONAL INJURY OR DEATH
FROM THE THROWING ARM.
WARNING: ADJUSTING THE ARM TO STOP AT A POINT TOO CLOSE TO THE
TRAP BODY CAN RESULT IN THE ARM CONTINUOUSLY FIRING OR FIRING
UNEXPECTEDLY WHICH COULD RESULT IN PERSONAL INJURY OR DEATH
FROM THE THROWING ARM.
Loosen these
2 screws
Pivot switch this
direction to stop arm
closer to edge of
top plate
Pivot switch this
direction to stop arm
further from edge of top plate
2.5" - 4.5"
17
Slide plate
lines up with
top plate