Operation - Champion RANGE AND TARGET WHEELYBIRD 2.0 Mode D'emploi

WARNING: DO NOT STAND IN FRONT OF TRAP OR IN THE PATH OF THE
THROWING ARM! SERIOUS INJURY OR DEATH MAY RESULT!
1. The throwing arm path indicator must be mounted properly before using trap.
2. Make sure that the trap is located to allow ample clearance around machine and provides
safe access to the rear of the trap during operation. The trap must be located so that the
user has safe access to the rear to operate the On/Off/Safe Release switch and reload the
trap.
3. Make sure that the On/Off/Safe Release switch is in the "OFF" position, and the arm is in
the uncocked position (page 6).
4. Place six (6) targets into magazine and hold them flat. Pull back on Target Retainer
Loading Bar if the Rubber Target Retainer interferes with the targets.
Rubber
Target Retainer
Target Retainer
Loading Bar
5. Release the Target Retainer Loading Bar if it was being held. The rubber target retainer
should be pressing on the 2nd target. Release the targets. Continue to load targets into
the magazine column.
6. After the targets are loaded, connect the trap to a fully charged 12V battery, ensuring
the remote release cord is safely away from and behind the trap.
7. Turn the On/Off/Safe Release switch to the "ON" position.
8. The trap should cock the throwing arm and at the same time drop one target onto the
throwing arm as it is cocking.
9. Activate the Foot Pedal Switch and the WHEELYBIRD 2.0™ Trap will release the throwing
arm (launching the target), re-cock the throwing arm and deliver another target to the
throwing arm.
WARNING: IF THERE IS A TARGET ON THE THROWING ARM, SAFE RELEASING
THE THROWING ARM WILL THROW THE TARGET. DO NOT STAND IN FRONT OF
THE TRAP.
10. When reloading the trap, first move the ON/OFF/SAFE RELEASE switch on the trap to the
"SAFE RELEASE" position momentarily to uncock the throwing arm. Allow the switch to
return to the "OFF" position. The trap magazine can then be safely reloaded with targets
from the rear of the trap.
V. Operation
15