Attach Throwing Arm Path Indicator - Champion RANGE AND TARGET WHEELYBIRD 2.0 Mode D'emploi

(C) Assembly (con't)

Attach Throwing Arm Path Indicator

1. Attach Throwing Arm Path Indicator Tube Support (A1) to each front side of trap by
threading arm path tube support into chassis.
2. Thread Throwing Arm Path Indicator Tube Stud (A2) into each rear tapped side hole of
trap and tighten securely.
3. Unwind Throwing Arm Path Tubing (A3) and thread thru each Throwing Arm Path
Indicator Tube Support (A1) and connect each end to Throwing Arm Path Indicator
Tube Stud (A2).
WARNING: FAILURE TO KEEP HANDS AND BODY OUTSIDE THE THROWING
ARM PATH INDICATOR AREA CAN RESULT IN SERIOUS INJURY OR DEATH FROM
BEING STRUCK BY THE THROWING ARM DURING USE.
CAUTION: DO NOT LIFT TRAP BY THROWING ARM PATH INDICATOR TUBING, OR
THROWING ARM PATH INDICATOR TUBE SUPPORTS, THESE WERE NOT DESIGNED
TO BE A LIFTING POINT.
A2
Throwing arm path indicator tube support
screws directly into frame
12
A1 A3