Installing The System In The Rack - Dell VersaRails Guide D'installation

Figure 1-6. Installing the VersaRails Slide Assemblies
mounting-bracket flange
10-32 x 0.5-inch flange-
head Phillips screw
(4 per slide assembly)

Installing the System in the Rack

CAUTION:
position in the rack.
CAUTION:
1
Pull the two slide assemblies out of the rack until they lock in the fully extended position.
CAUTION:
assemblies by yourself.
2
Lift the system into position in front of the extended slides (see Figure 1-7).
3
Place one hand on the front-bottom of the system and the other hand on the back-bottom
of the system.
1-14
Rack Installation Guide
slide assembly (2)
front of rack
If you are installing more than one system, install the first system in the lowest available
Never pull more than one component out of the rack at a time.
Because of the size and weight of the system, never attempt to install the system in the slide