Electrolux KTI8402BE Notice D'utilisation page 16

16 www.electrolux.com
Two phase connection
1. Remove the cable end sleeve from
black and brown wires.
2.
Remove insulation of the brown and
black cable ends.
3. Apply a new wire end sleeve of 1.5
mm² on each cable end. (Special tool
required)
WARNING!
All electrical connections must be
made by a qualified electrician.
One phase connection — 230 V~
8.3 Assembly
230V~
N
L
Green — yellow
N Blue and gray
L Black and brown
min.
500mm
Two phase connection — 400 V 2 ~
Green — yellow
Blue and gray
Black
Brown
min.
50mm
min.
2mm
CAUTION!
Do not drill or solder the wire
ends. This is strictly forbidden!
WARNING!
Do not connect the cable without
cable end sleeve.
400V 2~N
N
L1
L2
N
N
L1
L2