Finishing; Glass Ember Installation; Glass Front Installation - Napoleon EFL100 Instructions D'installation Et D'utilisation

4.0 FINISHING

POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1

GLASS EMBER INSTALLATION

NOTE: Glass front must be removed and the appliance must be mounted in its fi nal location before the
glass embers are installed.
Glass embers may have sharp edges, wear safety glasses and gloves
when handling.
A. CLEAN GLASS MEDIA: Glass media may have a fi ne oil residue
that needs to be cleaned prior to installation. Clean the glass with
mild dish soap, drain, rinse thoroughly and dry before placing into
the tray.
B. Carefully place glass embers into the bottom tray on the front of the appliance as illustrated. Apply an
even layer from side to side.
NOTE: It is not necessary to use all of the glass media supplied.
4.2

GLASS FRONT INSTALLATION

It is necessary that two people install this glass front onto the appliance, Wear
safety glasses and gloves when handling glass. Take care when handleing the
glassm ensure not to damage, or chip the glass.
A. Line up the brackets on the back of the glass with the 4 shoulder screws
on the side of the appliance body.
B. Slide the glass in and downwards, ensuring the bracket has engaged to
the shoulder screw prior to releasing the glass.
C. For glass front removal reverse these steps.
WARNING
!
RECONSTRUCTION.
11
EN
Shoulder
Screw
W415-1140 / A / 07.04.13