Installing The Weighing Pan; Connecting Power; Battery Installation; Initial Calibration - OHAUS Scout SKX Serie Mode D'emploi

EN-2 SKX BALANCES

2.3 Installing the Weighing Pan

Balances with a rectangular pan are placed into the sub-pan as shown and rotated counter-clockwise until it locks. Round
pans are placed straight down on sub-pan.

2.4 Connecting Power

AC Adapter Installation
Connect the AC adapter power cord to the instrument's power input connector, and then connect the AC plug to a suitable
electrical outlet.
Attention: Only use a AC adapter specified by OHAUS.
Weigh Below Hole
Security Slot (Anti-Theft lock slot)
Option Interface
AC Adapter Input Jack
Security Switch
Battery Compartment Cover

Battery Installation

Install the four "AA" batteries with polarity as shown in the battery compartment.

2.5 Initial Calibration

For best results, the instrument's calibration should be checked prior to first use. If adjustment is needed, refer to the
Calibration section of the instruction manual.