Christie LX120 Guide De Référence Rapide page 3

LENS INSTALLATION
Before setting up a projector, install Projection Lens on the Projector.
1. Before installation, check where the projector is used and prepare suitable lens. For specifications of the
Projection Lens, refer to the manual separately attached or contact sales dealer where you purchased the
projector.
2. For installation, refer to the installation manual supplied to the Projector.
When moving or setting up the projector, be sure to replace the Lens Cap to protect the surface.
And be careful not to hold or subject the lens to strong forces. It may damage lens, cabinet, or
mechanical parts.
POSITIONING THE PROJECTOR
This projector is designed to project on a flat projection
surface.
ROOM LIGHT
Brightness in the room has a great influence on
picture quality. It is recommended to limit ambient
lighting in order to provide best image.
VENTILATION
This projector is equipped with cooling fans to protect it from
overheating. Pay attention to following to ensure proper
ventilation and avoid a possible risk of fire and malfunction.
● Do not cover vents with papers or other materials.
● Keep rear grill at least 3.3 feet (1 m) away from any
object.
● Make sure that there are no objects under the
projector. Any object under the projector may
prevent the projector from taking cooling air through
bottom vent.
LENS SHIFT ADJUSTMENT
Projection lens can be moved up, down, left and right with motor-driven lens shift function. This function
makes it easy to provide projected image where you want.
Use the LENS SHIFT button
and the POINT UP/DOWN
button to move image up or
down.
MOVED UP OR DOWN
SCREEN
AIR INTAKE VENT EXHAUST VENT
(BOTTOM SIDE) (REAR SIDE)
Use the LENS SHIFT button
and POINT LEFT/RIGHT
button to move image left or
right.
MOVED LEFT OR RIGHT
English
PICTURE LEVEL AND TILT ADJUSTMENT
Picture tilt and projection angle can be adjusted with
handles on both sides of a projector. Projection angle
can be adjusted to 5.7 degrees upper way.
1
Press the knob on the handle. The handle pops
out.
2
Turn handles (right and left) until the picture is
projected on proper position. Adjust height of rear
adjustable feet by rotating them until the projector
is properly stabled on the table.
3 Press the knob and retract the handle.
INSTALLING PROJECTOR IN PROPER POSITION
Install the projector properly. Improper installation may reduce the lamp lifetime and cause a fire hazard.
Do not tilt the projector more than 10 degrees above and below.
Do not point the projector up to project an image.
NO UPWARD
Do not point the projector down to project an image.
NO DOWNWARD
Do not put the projector on either side to project an image.
NO SIDEWAYS
REAR ADJUSTABLE
FEET
LEVEL AND TILT
ADJUST HANDLE
KNOB
ADJUSTABLE
FEET
Height of front feet can be
adjusted by turning handles.