Your Air Purifier; Product Overview (Fig.a); Controls Overview (Fig.b); Getting Started - Philips 1000i Série Mode D'emploi

2 Your air purifier

Congratulations on your purchase, and
welcome to Philips!
To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
Product overview (
A Control panel
B Air quality light
C
Air outlet
D Air quality sensor
NanoProtect True HEPA filter
E
(FY1410)
NanoProtect Active Carbon filter
F
(FY1413)
G Pre-filter
H Air inlet
I
Front panel
Controls overview (
J On/Off button
K Night sensing mode button
L Display screen
M Fan speed button
N
Child lock button
8 EN

3 Getting started

Installing the filters

• Make sure the air purifier is unplugged
from the electrical outlet before
)
Fig.a
installing the filters.
• Make sure the side of the filter with the
tag is pointing towards you.
1
2
3
4
5
6
)
Fig.b
• Make sure the side with the clip is
pointing towards you, and that all
hooks of the pre-filter are properly
attached to the purifier.
7
8
Note
Pull the bottom part of the front
panel and gently lift to remove it
from the air purifier (Fig.c).
Press the clip down (1) and pull the
pre-filter towards you (2) (Fig.d).
Remove all filters (Fig.e).
Remove all packaging materials
from the filters (Fig.f).
Place the thick HEPA filter (FY1410)
into the air purifier and then the
thin Active Carbon filter (FY1413)
(Fig.g). The model numbers are
shown on each filter.
Attach the pre-filter back into the
air purifier (Fig.h).
Note
Reattach the front panel by
pressing the top part of the panel
onto the top of the air purifier (1).
Then, gently push the panel against
the body of the air purifier (2)
(Fig.i).
Wash your hands thoroughly after
installing filters.