Connection; Commissioning; Advice For The User; Disposal - oventrop W-HTE Notice D'utilisation

Instantaneous water heater for Regudis W-HTE

Commissioning

4.4.3

Connection

The connecting cable must have a
conductor cross section of at least 2.5 mm 2 .
f
Lead the connecting cable downwards
(recommended) or to the left out of the
cabinet by a short route.
5. Commissioning
NOTICE
Damage to the screed due to wrong
temperatures
f
Proceed to an incremental heating test
of cement and calcium sulphate screed
according to DIN EN 1264-4.
f
Follow the manufacturer's
specifications
for all screed materials.
f
Adjust the flow temperature to the
surface heating.
f
Do not exceed the screed temperature
specified in DIN EN 1264-4 near the
heating pipes.
Check all components and couplings for
leaks.
f
Put your dwelling station into operation as
described in the operating instructions for
your Regudis W-HTE.
We recommend setting the potable water
temperature at your dwelling station 5°C
higher than at the instantaneous water
heater to prevent unnecessary electrical
reheating.
f
Put the instantaneous water heater into
operation as described in the chapter
"Initial commissioning" in the enclosed
"Installation instructions for qualified
tradespeople".
Select setting 13.5 kW.
134456180-V01.03.2021

6. Advice for the user

Observe the notes in the enclosed
"Instructions for the user".
7.

Disposal

When the product reaches the end of its
service life or has an irreparable defect, it must
be dismantled and disposed of in an
environmentally friendly manner or the
components must be recycled.
Directive 2012/19/EU WEEE:
Waste electrical and electronic
equipment (WEEE) must not be
disposed of with domestic waste, but
must be dropped off at a collection
point for the recycling of electrical
and electronic appliances.
EN
21