Getting Familiar With The Appliance; Control Panel; Heating Elements; Operation - Bosch NEM5066UC Mode D'emploi

Getting familiar with the appliance

In this section we describe the control panel, elements
and displays.

Control panel

Knob positions
Off Cooking element turned off
1-9 Heat levels
Heat setting for inner ring of a dual element
$
Heat setting for inner and outer ring of a dual
ð
element

Heating elements

Element
Single element
$
Dual element
ð

Operation

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Adjust the heat setting of the elements using the knob:
Push in and turn the knob to the desired temperature.
Heat level 1 = minimum power
Heat level 9 = maximum power
When the element turns on, the power-on indicator lights
up.
These instructions apply to more than one cooktop, your
appliance might vary slightly.
Page 2 contains a list of models and dimensions.
Light Indicators
$
On/Off
®
NOTICE: Always keep the control knobs clean and dry.
Moisture and dirt can affect proper functioning.
Turning on and off
Single elements have only one size cooking surface.
Always use cookware of a suitable size.
The size of these elements can be matched to your pan size.
Using the inner and outer ring: Turn the knob to the left.
Using only the inner ring: Turn the knob to the right.
Turning off
Turn the control knob to OFF. When all control knobs are
in the OFF position, the cooktop is turned off.
Note: The heat is turned on and off to regulate the
temperature of the element; this means that the red glow
below the element is not always visible. When you select
a low heat setting, the element turns off for longer
intervals, while at a higher setting these intervals are very
short. Even at the highest level, the element turns on and
off.
Cooktop is turned on
Cooking element is turned on
9