Code Search - Acoustic Research ARRS05G Manuel D'utilisation

You can program the remote's device keys for the following kinds of
devices:
TV
DVD/VCR
CBL/SAT (DTC)
Audio
Aux
To reassign a device key to control a different kind of device (a
second TV, for example), see page 11.

Code Search

The code search allows you to scan through all the codes contained
in the remote's memory. If your device does not respond to this
remote after you have tried all the codes listed for your brand (or
if your brand is not listed in the code list), use the code search to
program the remote.
To search for your device's code:
1. Make sure your device is on (not in standby mode).
6
Television
DVD player, video recorder
Cable box, satellite receiver, or
digital TV converter
Amplifier, amp/tuner
Video accessory device, digital
TV converter
2. Press the device key on this remote for
the device you want to operate.
3. Press and hold SET until the device key
blinks twice (the red indicator blinks
once, then twice).
4. Press 9 9 1. The device key blinks twice.
5. Press POWER.
6. Aim the remote at the device you want
to control. Press CH+ over and over,
until your device turns off (every time
you press the CH+ key remote sends
out a POWER signal from the next code
contained in the memory). You may
have to press this key many times (up to
150 times) so you'll need to be patient. If
you skip past a code, you can go to the
previous code(s) by pressing the CH–
key. Remember to keep pointing the
remote at your device while pressing
this key.
7. As soon as your device turns off, press
and hold SET until the device key
blinks twice to store the code (the red
indicator blinks twice).