Setting Up The Remote - Acoustic Research ARRS05G Manuel D'utilisation

Setting Up the Remote

Before you can start using this remote to control your home
entertainment system, you need to program it to operate those
devices.
To program this remote to operate a device:
1. Find the code for your device in the accompanying code list.
Codes are listed by device type and brand name. The most
popular code is listed first. Make sure your device is switched on
(not in standby mode).
6. Turn your device back on and try all the remote's functions to
ensure they operate properly.
IMPORTANT:
By default, the CH +/– and VOL +/– keys are locked to the
following devices regardless of what mode you're in.
CH+/– changes channels for CBL/SAT (DTC) only.
VOL+/– controls volume for TV only.
Don't test the CH+/– keys unless you're programming the
CBL/SAT (DTC) key. Don't test the VOL+/– keys unless you're
programming the TV key.
If the functions do not work properly, repeat steps 1 to 5 using
another code listed under your brand. If none of the codes listed
for your brand operate your device, or if your brand is not listed
at all, try the Code Search described on page 6.
Notes:
• Some codes are quite similar. If your device does not respond or is
not functioning properly with one of the codes, try another code
listed under your brand.
• If your device's original remote control does not have a POWER
key, press PLAY instead of POWER when setting up your device.
• Remember to press the corresponding device key before
operating your device.
2. Press the device key on this remote for
the device you want to operate.
3. Press and hold the SET key until
the device key blinks twice (the red
indicator underneath the device key
blinks once, then twice).
4. Enter your four-digit device code using
the number keys. The device key blinks
twice.
5. Now, aim the remote at your device and
press POWER. If your device switches
off, the remote is ready to operate your
device.
5