Bosch CRS-WD-TA869 Manuel D'installation page 14

14 en | Installation Manual
3. When also using a housing
contact as a wall tamper contact,
pull out the "wall insert".
4. Installing the housing base.
- If necessary, install the "wall
insert" for the wall tamper contact.
- When connecting external
contacts, see "Connecting External
Contacts" chapter.
F.01U.045.269 | V4 | 2014.12
5. Remove the battery interrupter
for the supply voltage.
6. When placing the second battery,
you can select the AIM Mode.
a) Press the tamper contact and
keep it pressed while inserting the
second battery.
b) The LED will light up for 3
seconds, then flash shortly once for
Mode 1, twice for Mode 2 or three
times for Mode 3.
c) To select the AIM mode, release
the tamper switch just after the
number of flashes corresponding to
the mode. Once the mode is set, it is
memorized permanently and the
LED blinks several times to confirm.
d) To check the selected mode, take
out the batteries and insert them
again. The LED lights up for 3
seconds, then flashes the number of
times corresponding to the selected
mode.
Installation Manual
CRS-WD-TA869
Bosch Security Systems