S&P CB-2005N Mode D'emploi page 22

4. MAINTENANCE
Before starting any maintenance operation don't forget to let the device cool down for a few
minutes and unplug it from the mains.
• This product requires regular cleaning (at least once a year) to avoid dust build-up at the
rear (air inlet), as this could cause overheating.
• Unhook the device from the wall and clean the dust built up at the air inlet with a vacuum
cleaner.
• Clean the body of the device with a wet cloth. Do not use detergents or other abrasive pro-
duct that could damage the fi nish / colour of the plastic.
• Do not immerse the device or spray water onto it.
5. END OF SERVICE LIFE / RECYCLING
EEC law and the duty we have to future generations oblige us to recycle; please do
not forget to dispose of all the excess packaging in the corresponding recycling bins
and to take replaced devices to the nearest Waste management centre.
6. DISMANTLING, RECYCLING OR DISPOSAL OF THE PRODUCT AT THE END
OF ITS SERVICE LIFE
If scrapping the device, you must adhere to regulations on the disposal or recycling of the
materials and components.
List of the heater's main materials:
• Rear in PP plastic.
• Front cover in ABS.
• Front and side grills in PBT plastic.
• Metal plate.
• Plastic impeller.
• Electronic Boards with tin.
• Electric wires in copper.
• Resistor with mica and Ni Cr wire.
7. TECHNICAL SUPPORT
The extensive Offi cial S&P Services Network provides any technical support you may require.
If you observe any anomaly in the device's operation, please contact any of the mentioned
services, where your request will be duly dealt with. Any handling not strictly necessary for
the installation of the device, carried out by persons other than staff of Offi cial S&P Services
will force us to cancel your warranty. For any queries regarding S&P products, please contact
the After Sale Services Network if in Spain or your usual dealer in the rest of the world. To
fi nd out where this is, you can go to the WEBSITE: www.solerpalau.com
22