S&P CB-2005N Mode D'emploi page 18

2. INSTALLATION
NB: Before installing the device, read all the Safety Warnings indicated in the correspon-
ding section.
2.1. Fix the metal frame onto the rear of the device with its corresponding bolt. See FIGURE
3-A. Note: Do not use an electric screwdriver.
2.2. If you have purchased the TOWEL RACK CB-2005N (sold separately), this must be fi xed
to the heater before the heater is fi xed to the wall, as follows:
• Put the device on a soft surface, with the rear part facing upwards.
• Put the TOWEL RACK KIT in the position indicated in FIGURES 3-4.
• Place the two plastic parts as indicated in FIGURE 5-B, and fi x them with their 6 bolts.
Note: Do not use an electric screwdriver.
• Make sure the TOWEL RACK KIT moves correctly (See FIGURE 6).
2.3. You can mark the correct position of the holes with the paper template provided. Mark
and make the 3 x Ø 6 mm holes on the wall (See FIGURE 7A). If you have purchased the
TOWEL RACK CB-2005N (sold separately), you must make 5 x Ø 6 mm holes as indicated
on the same paper template (See FIGURE 7B).
2.4. Once you have made the holes, insert all the wall plugs and screw in the two top screws,
making sure there is 3 mm of separation between the head of the screw and the wall. The
3 mm separation can be achieved with the plastic wedge provided (See FIGURE 7 A-B).
2.5. Hang the device on the two top screws (FIG 8.1 - 8.2) and secure it with the screw on the
bottom (FIG. 8.3). If you purchased the TOWEL RACK CB-2005N (sold separately), you
must also secure it to the wall with the two lateral screws (FIG 8.4).
NB: Don't use an electric screwdriver to tighten the screws.
3. PLUGGING IN AND USING THE DEVICE
NB: Before plugging in the device, make sure the mains voltage matches that indicated on
the data plate.
NB: Before using the device, read carefully all the Safety Warnings indicated in the corres-
ponding section.
3.1. Connect the device's power cord to the mains socket.
3.2. Actuate the master switch situated at the rear of the device (ON / OFF).
NOTE: If the device is not going to be used for a long time (summer), we recommend turning
it off with this master switch.
18