Important; Error Message - S&P CB-2005N Mode D'emploi

• To execute the week's program previously entered, press
on without fl ashing. On screen we will see the day of the week we are at and the ON / OFF
times set for that day.
NOTE: In AUTOMATIC operating mode, the heater always connects at maximum power and
this cannot be changed.
NOTE: Once we have entered the desired weekly programme, we can also use the heater in
manual mode, bearing in mind that AUTOMATIC operating mode has priority over MANUAL
operating mode.
3.8. Presence sensor
• The presence sensor is only active in automatic operating mode. If after 15 minutes' au-
tomatic operation the presence sensor does not detect movement in the bathroom, it will
stop. If movement is detected within the set time, it will start operating again, following
the set weekly programme. The Area of infl uence of the presence sensor is indicated in
FIGURE 8.
NB: The heater incorporates a turn-off delay of 30 seconds to cool the device. Do not turn
off the device with the master switch (ON / OFF), or by unplugging it directly from the mains.

3.9. Error message

If the error message (E1) appears on the screen, please contact the After Sale Services Ne-
twork if in Spain or your usual dealer in the rest of the world. To fi nd out where this is, you can
go to the WEBSITE: www.solerpalau.com
• Set the thermostat temperature by pressing (
Confi rm again by pressing (OK). We recommend a comforta-
ble temperature of 22-23ºC.
• Set, by pressing (
want the heater to turn off automatically. Confi rm with the
(OK) key. You will automatically skip to Tuesday's program-
ming (2), and so on for all days of the week, ending on Sunday
(7).
• IMPORTANT: If on one day of the week we DON'T want the
heater to turn on, we press the (SET) key for this day and con-
fi rm by pressing (OK). OFF will appear on screen for said day.
/ ), at what hour / minutes you
until the icon (
/ ).
) comes
21