Operating Controls; Operating Times; First Use; Assembly - Wolf Garten LYCOS 40/300 T Mode D'emploi

Operating controls

Operating controls
Operating elements
1 Power pack release
2 Handle
3 Eco button
4 Hook for carrying belt
5 Middle handle
6 Fastening sleeve
7 Protective cover
8 Line spool
9 Line knife
10 Power pack compartment
11 On/off switch
12 Lock-on switch
13 Standoff holder
14 Carrying belt
15 Nut for retaining dome
16 Retaining dome
17 Cutting blade
18 Blade safety cover
Supplementary documentation
Make sure the supplied instruction man-
uals of the charger and the power pack
are available. Please read and under-
stand them before using the device.
Power pack charging
Risk of injuries or material damage.
Only charge the power pack using the
charger approved by the manufactur-
er. The designations of the approved
chargers are listed in the enclosed CE
Declaration of Conformity.
Attention!
The power pack is supplied partially charged. Be-
full capacity of the power pack.
Power pack charging must be carried out ac-
cording to the instructions in the supplementary
documentation.

Operating times

Observe the times stipulated in local byelaws.
Check with your local authorities to determine if
there are any operating time limitations.

First use

WARNING!

Assembly

Assembling the protective cover
Press the outer edge
protective cover until it engages
Secure the outer edge with the long screws
and tighten by hand
Fitting the protective cover
Position the protective cover on the trimmer
head .
Screw on the protective cover with the short
screws . Only tighten the screws by hand.
Connecting the shaft of the trimmer unit to the
operating arm
Align the shaft and arm in such a way that the
recess and the retaining collar are opposite to one
another.
Insert the trimmer unit in the holder of the oper-
ating arm .
Fully tighten the fastening sleeve
Fitting the middle handle
on the arm of the operating module
the two adjustment limiters (a).
Place the middle handle
that the holes lie on top of one another in a con-
centric manner .
Press the bolts
with the depression for receiving the bolt head.
Position the washer
bolt from the other side and tighten the nut by
hand .
other end of the bolt
Align the middle handle on the arm so that the
imprinted arrow on the fastening piece is aligned
with the marking line on the arm.
Secure the middle handle in this position, by
nut .
Note
into the recess of the
.
.
.
between
into the holes from the side
and the nut
by hand on the
.
EN
on the
27