Decorative Cutting; Servicing - Wolf Garten LYCOS 40/300 T Mode D'emploi

EN
Tips for optimum trimming results when work-
ing with the line head
Hold the cutting attachment parallel to the ground.
Only cut with the tip of the line, especially along
walls. Cutting with more than the tip reduces the
cutting ability and can overload the motor.
Where grass is longer than 20 cm, cut from the
top to the bottom in small steps to prevent prema-
ture wear of the line and overloading of the motor.
If possible, cut from left to right. Cutting to the right
improves the cutting ability of the device. Grass
cuttings are then thrown away from the user.
Move the device slowly at the desired height into
and out of the cutting area. Move either forwards
and backwards or from side to side. Cutting
smaller areas achieves better results.
Only carry out cutting when grass and weeds are
dry.
Note
-The plants being cut
-Where they are cut
when cutting along a house wall than when

Decorative cutting

You can obtain a decorative cut, when you are cut-
ting all plants around trees, posts, fences, etc.
Rotate the entire device, so that you are holding the
cutting attachment at an angle of 30° to the
ground .
Operation using the cutting blade
Before you use the device, hold it in the operating
position. See "Holding the device".
Tips for operation using the cutting blade:
Cut with an even cadence.
Adopt a steady and comfortable posture on the
ground.
Do not use eco mode. The blade then has max-
imum cutting force and does not jam so easily,
remain stuck, or cause impacts to the blade that
could result in serious injuries to the user or other
persons.
Cut by turning the upper part of your body from
right to left.
Turn the device in the same direction in which the
blade cuts. This helps cutting.
Take one or two steps forward to the next area
30
Follow the guidelines below to reduce the possi-
bility that plants will wind around the blade.
- Do not cut in eco mode.
- Swing from right to left into the plants to be cut.
- Avoid plants that have just been cut,
while they are swinging back.
Removing the power pack
Press the power pack release
Remove the power pack

Servicing

Risk of injuries or material damage due to
moving parts.
Only clean or service the device if the
motor is stationary and also the cutting
tool.
Always remove the power pack prior to
working on the device.
Do not clean the device with water.
Repair and service work as well as the
replacement of safety elements must
workshop.
Cleaning the device
comes to a standstill before removing the power
pack.
Clean the device with a hand brush after every
use.
Clean the ventilation slots and underside of the
device at regular intervals to remove grass resi-
dues.
Cleaning the cutting blade
To remove all residues, clean the cutting blade
using a domestic cleaning agent.
Oil the blade with machine oil to protect it against
rust.
Cleaning the line head
After any use, clean the line head from the outside
with a brush or cloth.
Clean the inside of the line head regularly when
in :
- Simultaneously press both retaining lugs
- Remove the remainder of the line from the
spool.
-
.
.
WARNING!
.
.
Servicing
and