Wolf Garten LYCOS 40/300 T Mode D'emploi page 25

For your safety
blade that is still rotating may cause injuries.
come to a complete standstill.
If you impact debris or get caught up in
motor and check for damage. The damage
to use the device. Do not use the device with
a bent, cracked or blunt blade. Discard any
bent, distorted, cracked or broken blades.
Do not sharpen the cutting blade. The sharp-
This could result in serious injuries. Replace
the blade.
Only transport or store the device with the
Information about vibrations:
Vibrations can cause nerve damage and
impair the blood circulation in the hands and
arms.
When working in the cold, wear warm clothing
and keep your hands warm and dry.
Take breaks.
or hands goes numb, tingles, hurts or goes
white, stop working with the device and, if
necessary, consult a doctor.
- Were measured according to a standardised
testing procedure.
- Make it possible to estimate the power tool emis-
tools. Dependent on the conditions of use, the
state of the power tool or tools inserted for use
with it, the actual vibration load may be higher or
lower. When estimating the emissions, consider
doing so during work pauses and phases when
the tool is under reduced load. Based on the
correspondingly adjusted estimated values, take
protective actions, e.g. organisational actions.
After use
and check the device for damage. Attention,
danger! Cutting tool still running!
If you need to clean or service the device,
Always wait until the cutting tool comes to
a standstill and do not touch any moving
power pack.
Safety information
All work on the device such as replacement of
the cutting line, conversion to operation with
the cutting blade, adjustment work, cleaning,
etc., must only be performed after the power
pack has been removed.
Use only original replacement lines/cutting
Ensure that ventilation slots are free from dirt.
Do not clean the device with water.
Store the device in a secure location.
Store the device out of reach of children.
Do not repair the device yourself; it must be
Let the device cool down before putting it
away and/or storing it.
General safety information
Never replace the non-metallic cutting ele-
ment with a metallic cutting element!
Always wait until the cutting tool comes to
a standstill and do not touch any moving
power pack.
Spare parts must meet the requirements of
the manufacturer. Therefore, use only original
spare parts or those spare parts authorised by
the manufacturer. During replacement, always
the power pack in advance.
technician or service centre. Specialist work-
shop addresses can be found on our website.
Ensure maintenance work is always per-
formed to schedule so that the device remains
in a safe condition.
Only use the power packs intended for this
purpose in power tools. Use of other power
This device is intended for the care of lawn
edges and smaller grass and lawn areas, and
when used with the blade, for the cutting of
brush, bushes and undergrowth in private
households. The device must not be used for
purposes other than those intended because
of the risk of bodily injury to the user or other
persons.
EN
25