Setup Instructions; Pump Installation - Blue Wave RX600 Manuel De L'utilisateur

Before assembly, take a few minutes to identify and become familiar with all the parts.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Suction & Return Fittings Installation
1. Set up your pool following the pool Owner's Manual instructions. Do NOT
fill water until the Filter Pump is properly installed. Locate the Outlet and
Inlet openings on the pool wall.
Inlet
Outlet
3. From inside the pool, install the Return Fitting
Inside Pool Wall
10

SETUP INSTRUCTIONS

into the Inlet opening.
6
Outside Pool Wall
2. From inside the pool, install the Suction Fitting
Outside Pool Wall
4

Pump Installation

4. Take out the Filter Pump Assembly
Clamps .
q
11
into the Outlet opening.
2
2
1
3
Inside Pool Wall
, two Hoses and four Hose
w 9
9
10