Before Using The Pump - Blue Wave RX600 Manuel De L'utilisateur

5. Connect the Suction Fitting to the Pump inlet with a Hose and one
2
Clamp on each end.
Make sure the Hose Clamps
both the Hose and O-Rings
9 k
7. Tighten all the Clamps to prevent water leakage.
q
4
10
9
9. Vent the Pump: to release the air trapped inside and make sure a smooth
water flow, it's important to vent or depressurize the Pump before each use.
Simply twist counterclockwise to loosen the Vent Screw
pressure will force all the trapped air out. Retighten the Screw when water
starts flowing out.
14
seals tightly over
q
.
q
k
9
10
9
, and the water
e
12
OWNER'S MANUAL
6. Connect the Return Fitting
one Clamp on each end.
6
9
2

Before Using the Pump

8. You can now fill the pool with water up to the FILL LINE.
Do NOT plug the Pump in at this point.
10. To optimize water circulation, twist the RF Diverter
down and away from the Suction Fitting.
Inside Pool Wall
to the Pump outlet with another Hose and
6
so that it faces
7
360°
11