Assembling D-Ring Connector To Turbolite Units - Sperian Miller Twin Turbo Manuel D'utilisation

4.0 Assembling D-Ring Connector to TurboLite Units

WARNING:
An authorized person should perform installation of TurboLite units into the
D-Ring Connector. All Miller Self-Retracting Lifelines must be inspected and tested before
each use (see 7.0 Inspection and Maintenance).
Rotate D-Ring Pin Retainer Clockwise
to the fully open position.
(a) Tilt D-Ring Connector back to allow D-Ring Pin to
slide clear of the D-Ring Slot.
(b) Rotate D-Ring Pin Retainer against D-Ring Pin
to hold in place.
D-Ring Pin
Retainer
D-Ring Pin
(a) Slide Outer Frame to one side as shown.
(b) Remove PFL Retainer Pin and PFL Spacer
and set aside.
A.
Outer
Frame
U s e r In s t ru c t ion s - En g li s h
Step 1
D-Ring Pin
Retainer
Step 3
B.
D-Ring Pin Knob
A.
Step 5
PFL
B.
Retainer Pin
PFL Spacer
Rotate D-Ring Pin Knob Counter-Clockwise
until D-Ring Pin is free to move.
Remove Slide Lock Bolt using a 5/32" Hex
wrench and set aside.
Install PFL Spacer into TurboLite Swivel Loop
and place into slot in D-Ring Connector.
7
Step 2
D-Ring Pin Knob
Step 4
Slide Lock Bolt
Step 6
PFL Spacer
TurboLite
Swivel Loop