Warnings And Limitations - Sperian Miller Twin Turbo Manuel D'utilisation

The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
All synthetic material must be protected
from slag, hot sparks, open flames, or other
heat sources. The use of heat resistant
materials is recommended in these
applications.
Environmental hazards should be
considered when selecting fall protection
equipment. Equipment must not be
exposed to chemicals which may produce
a harmful effect. Polyester should be used
in certain chemical or acidic environments.
Use in highly corrosive or caustic
environments dictates a more frequent
inspection and servicing program to ensure

2.2 Warnings and Limitations

For use by ONE person only. The design
working load is 400 lbs. (181.4 kg) — DO
NOT EXCEED THIS WEIGHT.
Do not use the device if it does not
retract.
Always maintain tension on the lifeline
while retracting.
Device must be tested for locking before
each use. Do not use the device if the
brakes do not engage.
Self-retracting lifelines must be removed
from service if any part of the system
appears to be damaged or does not
pass inspection, or if the unit has been
subjected to the forces of arresting a
fall.
Do not attempt to service this device. If
a self-retracting lifeline does not operate
properly or requires repairs, return the
device to the equipment manufacturer,
or service center authorized in writing
by the manufacturer, for repairs. [Units
that do not pass inspection and are
not repairable must be disposed of
properly.]
Us er Ins tru ct ion s - Engl is h
4
the integrity of the device is maintained.
Contact Miller Technical Services if in doubt.
Do not allow equipment to come in contact
with anything that will damage it including,
but not limited to, sharp, abrasive, rough
or high-temperature surfaces, welding,
heat sources, electrical hazards, or moving
machinery.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
Never remove product labels, which include
important warnings and information for the
authorized person/user.
Do not lubricate this device.
The device must be kept clean and free of
contaminants.
The device should be installed and used
in such a manner as to minimize the
potential for a swing fall.
Do not allow lifeline to become slack.
Never work above the device, unless
mounted for use within a structure (e.g.
lifts, in accordance with installation
instructions).
Never use the device as a restraint or
positioning device.