Main Burner Flame Characteristics - Empire Comfort Systems OLL48FP12S-2 Instructions D'installation Et Mode D'emploi

MAIN BURNER FLAME CHARACTERISTICS

NEVER operate fireplace with an optional weather door in place.
In normal operation on high after 10 to 15 minutes, the flame ap-
pearance should be several tongues of yellow flames.
NOTE: All flames will be random by design, flame height will go
up and down.
During manufacturing, fabricating and shipping, various components
of this fireplace are treated with certain oils, films or bonding agents.
These chemicals are not harmful, but may produce annoying smoke
and smells as they are burned off during the initial operation of the
fireplace. This is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Any odors remaining after this initial break-in
will disappear with continued use.
Flames from the main burner should be visually out before the
weather door is installed.
If burner flame pattern is incorrect
• See Troubleshooting, page 26.
Flame Pattern
The main burner flame will be mostly yellow.
Flame Ignition and Extinction
When the main burner is ignited it may take up to a minute for the
full flame pattern to develop.
When the main burner is extinguished it may take up to a minute for
the flames to disappear. It is normal to have the flames burn down
near the burner, as the remaining gas is burned.
41308-2-0620
Figure 29
WARNING
Figure 31 - Correct Flame Propane
Figure 32 - Correct Flame Natural
Figure 33 - Incorrect Short Blue Flame
Figure 34 - Incorrect Tall Yellow Flame
Page 23