Dutch originals DO-CH-ACON120 Manuel D'utilisation page 13

by hand.
To control the horizontal (up/down) direction of the airflow, press the SWING button on the
H
remote control
FAN mode
You can ventilate your room. In this mode the air is circulated, creating a 'breeze feeling',
but the room will not be cooled.
Press the mode button on the device
on the digital control panel lights up.
9A
You can select the required FAN speed as described in "FAN speed"
Child lock
To activate the child lock, press and hold the fan SPEED button on the device
seconds, until the child lock LED indicator
To disable the child lock, press and hold the fan SPEED button on the device
seconds, until the child lock LED indicator
Note! The child lock can only be activated on the device.
Dehumidifying mode
Press the mode button on the device
indicator on the digital control panel lights up.
9D
In this mode, the FAN speed cannot be selected and will be in the default low speed
setting.
Note!
In dehumidifying mode, the drain hose
opening to release the condensed water.
9
See "Drainage" for connection instructions.
Smart mode
In the smart mode the cool and FAN mode will be automatically regulated, depending on
the room temperature.
Press the mode button on the device
indicator on the digital control panel lights up.
9B
Once the smart mode has been selected, the mode is activated in the default target setting
of 23°C.
At a temperature of ≥ 24°C, the device operates in cool mode.
At a temperature between 22°C and 24°C, the device operates in fan mode.
In SMART mode, the device automatically regulates the temperature and switches between
FAN & COOL mode. The temperature can only be adjusted when the device is cooling.
When it is in FAN mode, the temperature cannot be adjusted.
Sleep mode
The sleep mode can be activated in cooling mode.
After 1 hour the preset temperature is increased by 1°C, after another hour the preset
temperature will again be increased by 1°C (maximum 2 degrees increase).
Press the mode button on the device
or remote control
4
lights up on the display.
9E
switches off on the display.
9E
or remote control
4
E needs to be connected to the drain
or remote control
4
or remote control
4
EN 11
until the FAN LED indicator
E
until dehumidying LED
E
until the SMART LED
E
. The SLEEP LED indicator
E
for 3
3
again for 3
3
4