Dutch originals DO-CH-ACON120 Manuel D'utilisation page 10

Make sure the device is not exposed to direct sunlight.
Install the device in rooms of more than 12m2
Attach the exhaust hose
The device requires ventilation to the outside, so that the (hot) exhaust air and moisture
can be dispelled outside the room that is being cooled.
Do not replace or extend the exhaust hose, as it will result in decreased efficiency, and can
automatically shut down the device due to low backpressure.
1) Connect the window hose adapter
2) Extend the adjustable window kit
the length of your window. Connect the
window hose adapter
kit.
4) Connect the other end of the device
hose to the exhaust air outlet
A
6) Adjust the louver at the air outlet, the device is ready for use.
B
D to
B to the window
7
to one end of the exhaust hose
3) Close your window, and make sure
the window kit is well and firmly placed. If
needed, secure the window kit with duct
tape. The gap between the kit and the sides
of the window should be closed / sealed for
maximum efficiency.
5) Adjust the length of the flexible hose
and avoid bends. Place the device close to a
power socket.
EN 08
A
A