Fitting The Trimmer Guard And Trimmer Head; Assembling And Dismantling The Two-Piece Shaft - Jonsered GC 2225 Manuel D'utilisation

Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
A
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
• To dismantle, follow the instructions in the reverse
order.
Assembling and dismantling the
two-piece shaft
(GC2225C)
Assembly
• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
12 – English
ASSEMBLY
A
A
• Push the attachment into the coupling until the
attachment snaps into place.
B
• Before using the unit, tighten the knob securely.
C
Dismantling
• Loosen the coupling by turning the knob (at least 3
times).
Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.
C