Other Maintenance - Husqvarna Soff-Cut 2000 Manuel D'utilisation

Battery
The battery is maintenance free. If the battery ever requires
charging, use only a voltage regulated taper current charger
WARNING
- Connecting and disconnecting a battery can cause
sparks and short circuits. Do not short battery ter-
minals by allowing a wrench or any other object to
contact both terminals at the same time.
explode.
- Before connecting a battery, remove metal brace-
lets, wristwatch bands, rings, etc. Use gloves and
protective glasses or face shield when working with
a battery.
Protective Gloves
Eye Protection
Guards
Check all guards for damage and proper function daily espe-
cially the blade block. Blade block and cover should be secure
to the saw and not damaged. Lexan side covers on the blade
block should move freely up and down.
Diamond blade
to the arbor, loss of segments, warping or overheating. If any
blade shows any of these problems, discard the blade and
never use.
Skid plate
Inspect the skid plate daily for damage, excessive wear in the
blade slot, burrs on the concrete surface side, twisting and free
movement up and down when installed on the blade block.
Replace the skid plate with each new diamond blade. Never
reuse the skid plates or spalling and raveling may result.

OTHER MAINTENANCE

Explosion Danger
11
Saw controls
Inspect all controls for proper function daily. Check all the
interlocks for operation especially the engine on/off
switch for proper operation.
Belts
Inspect the blade drive belt and transmission belt for cracks
or signs of wear. The belt tension is controlled by belt
tensioner and does not require adjustment. Inspect the belt
tensioner for free movement up and down. Insure the belt
tensioner bearings roll freely.
Blade shaft bearings
Lubricate the blade shaft bearings with 3 pumps of Lithi-
um 12 based grease every 50 hours.
Cleaning
Clean the blade block of any excess concrete build up after
each use. Keep the handle bars and controls clean and
dry. Immediately clean any spilled fuel from the saw. Keep
all openings and slot on the engine shrouding on the saw
proper cooling.
MAINTENANCE SCHEDULE
Check guarding, diamond blade, skid
plate, lexan covers, controls and oil
levels.
Clean blade block assembly and saw.
Replace air cleaner.
Replace engine oil.
Grease blade shaft bearings.
Check blade drive belt, the transmission
drive belt and belt tensioner.
WARNING
Do not modify the saw! Use only Husqvarna
Construction Products replacement parts. Use of
unauthorized parts may create a danger or damage
the engine.
Daily
Daily
Every 50
hours
Every 50
hours
Every 50
hours
Every 50
hours