Result Codes - Bausch Proxima ISDN Lite Manuel D'utilisation

Syntax Value
X 0..4
X0
X1
X2
X3
X4
&C 0..2
&C0
&C1
&C2
&D 0..3
&D0
&D1
&D2
&D3
&K 0..4
&K0
&K1, &K3
&K2, &K4
&S 0..2
&S0
&S1, &S2
See also: &Q (communication mode)
5.6.1

Result codes

Result codes are sent to the serial port by the Terminal Adapter once a command line has been processed. The codes may
be given as text or as numbers. This is selected by using the ATV command.
Numeric Text
Def. Meaning
4 Dial and busy tone message and detection selection
Busy tone and dial tone detection off,
only CONNECT message
Busy tone detection off, dial tone detection off CONNECT xxx
message
Busy tone detection off, dial tone detection on CONNECT xxx
message
Busy tone detection on, dial tone detection off CONNECT xxx
message
Busy tone detection on, dial tone detection on, CONNECT
xxx message
1 Carrier Detect signal (CD, 109) behavior
Synchronous mode: CD follows 'carrier' status
Asynchronous mode:
CD always on
CD follows 'carrier'
CD on when on-line, off when 'carrier' is gone, back on in
rest
2 DTR (108) behavior (see also S123)
&Q0, &Q5: DTR has no effect
&Q1: DTR going off: break connection
&Q2: DTR going off: break connection
DTR off and on: start dialing
&Q0, &Q1, &Q5: DTR going off: to
command mode
&Q2: DTR going off: break connection
DTR off and on: start dialing
&Q0, &Q5 : DTR going off: break connection &Q1: DTR
going off: break connection,
DTR has to be on within time in S25 for
CONNECT. No Auto
Answer if DTR is not on.
&Q2 : DTR going off: break connection
DTR off and on: start dialing
No Auto Answer if DTR is not on.
&Q0, &Q1, &Q5: DTR going off: reset the
Terminal Adapter
&Q2: DTR going off: reset the TTA
DTR off and on: start dialing.
3 Flow control
No flow control
RTS-CTS flow control (hardware)
XON-XOFF flow control (software)
0 DSR (107) behavior during asynchronous mode (&Q0, &Q5)
DSR is always on
DSR is on when on-line, off in rest
Meaning
82
a
Type