Bausch Proxima ISDN Lite Manuel D'utilisation page 73

Figure 15: Outline of Proxima ISDN Lite Protocols
ati5
Proxima ISDN Lite V0.7, September 1998
Service Channel Bearer Typ/max rate Protocols
---------------------------------------------------------------------------
7 asyn PPP B data
8 asyn transp
9 asyn transp
10 asyn transp
13 asyn transp
16 GCI-speech B1,B2 voice
18 GCI-data
27 asyn transp B1,B2 data
28 asyn transp B1,B2 data
Remote control.
OK
The above list is an example. It is possible that your Proxima ISDN Lite will produce another outline due to software changes.
A protocol is selected by using the AT&O<n> command. To select the corresponding protocol, the number found in the left
column has to be entered for <n>. For example:
AT&O7
The factory setting is V.120 (&O10).
The AT&V command is used to display current settings. It can be used to check if the correct protocol has been selected. For
example :
at&v
DTE channel 10 (Asynchronous V.120) parameters:
E1 Q0 V1 W0 X4 \Q3 %C0
&C1 &D2 &K3 &M0 &O10 &Q0 &S0 &Y0
S000:000 S001:000 S002:043 S003:013 S004:010 S005:008 S007:060
S012:050 S025:000 S030:000 S039:003 S048:007 S095:000
S110:010 S111:008 S112:000 S113:025 S114:115 S116:000 S117:000
S119:000 S120:000 S121:253 S122:254 S123:000 S124:001 S126:000
S131:000 S133:080 S153:000 S154:000 S161:000
OK
Figure 16: Set Protocol
When the Proxima ISDN Lite is used in Windows, it isn't necessary to select protocols by using the AT commands.
Selecting the correct driver will do, the setting will be done automatically.
115.2/230.4 PPP conversion asyn-sync
B data 57.6/ 57.6 V.14
B data 19.2/ 38.4 V.110 asyn
B data 115.2/230.4 V.120 asyn
2B data 230.4/230.4 V.120 asyn, MLP
230.4
B1,B2 data 230.4 any
115.2/230.4 ML PPP RFC1990 asyn-sync
115.2/230.4 TRANSPARENT asyn-sync
PPP is the protocol selected
73