Chassis; Removing The Body; Fitting The Body Mounting; Fitting The Wheel Drivers - Carson On-Road Chassis 1:5 6S Brushless Mode D'emploi

cHaSSIS

Front tyre
Front shock
unit
Chassis

remoVIng tHe boDy

• Remove hook pin and

FIttIng tHe boDy mountIng

• The body mounting is fitted as shown in construction section
15
• Adjust the height of the mounting to match up with your
bodywork
• Make sure that the wheel and ground clearances are correct
Speed Controller
Switch ON/OFF
Receiver
Steering Servo
• Take body off.
• The rear wheel drivers are fitted as shown in construction
• Use the right wheel drivers to match up with your bodywork
• 6-mm rear wheel drivers for body widths of 40 cm (e. g. Audi)
• 17-mm rear wheel drivers for body widths of 42 cm
Motor

FIttIng tHe wHeeL DrIVerS

section 7
(e. g. Porsche)
Rear shock unit
Rear tyre
Driving battery box
15 // GB