Diseqc Setting - TechniSat SKYRIDER DOME Mode D'emploi

5.3

DiSEqC setting

By default, DiSEqC is turned off. If you want to use DiSEqC, your connected receiver must support at least DiSEqC 1.0 and its
satellite configuration must be set according to the table below.
> To enable or disable the DiSEqC function in the controller, press the DiSEqC button on the controller for 2 seconds.
The current status is indicated by the DiSEqC LED on the controller.
No. Position / Option
1 A / A
2 A / B
3 B / A
4 B / B
Satellite
Astra 28,5° East
Astra 19,2° East
Hotbird 13,0° East
Eutelsat 5,0° West
DE
EN
FR
IT
NL
PL
35