Programming Your Coffemaker; Se T Ti N G T He Au To Brew Delay - Black & Decker SPACEMAKER SCM200BD Guide D'utilisation Et D'entretien

Note: Always tighten screws to properly secure
the appliance to the cabinet and to ensure
the appliance does not move or shake during
operation.
13. Pull out cord from cord storage behind the
appliance and plug into a standard electrical
outlet. Extra cord can be fed back into
storage or hung over cord management
hook behind the appliance. (L)
Note: If you are connecting this appliance to the receptacle of another
SpaceMaker appliance such as the toaster oven or coffeemaker, make sure
™
you can easily unplug the appliance following use.
14. Your SpaceMaker
PROGR A M M I NG YO UR CO FFE E M AKE R
SE T TI N G T HE DI GITA L CLOCK
1. Plug your coffeemaker into a standard electrical outlet.
2. The entire digital clock will fl ash "12:00" to indicate that the time has
not yet been set.
3. Press the HOUR and MIN (minute) buttons until the correct time
appears on the display.
Note: A "PM" symbol will appear to indicate afternoon time settings.
This symbol will not appear for AM settings.
4. Your clock is now set.

SE T TI N G T HE AU TO BREW DELAY

1. Ensure the digital clock has been set (see "SETTING THE DIGITAL
CLOCK" section for assistance).
2. Press the PROG (program) button. The display will fl ash "12:00."
3. Press the HOUR and MIN buttons until they indicate the time you
would like automatic brewing to begin.
Note: A "PM" symbol will appear in the upper right hand corner of
the digital display to indicate afternoon time settings. This symbol
will not appear for AM settings.
4. The Auto Brew display will fl ash for a few moments before switching
back to the digital clock.
TIP: After programming, press the PROG button to check the preset Auto
Brew time.
appliance is now ready for use!
™
10
L