Before Brewing; Programming Your Cof Fee Maker - Black & Decker CM2036 Guide D'entretien Et D'utilisation

Cafetière programmable avec carafe isotherme de 12 tasses
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BE FO R E B R EWI N G
1.
To register your product, go to www.prodprotect.com/blackanddecker
2.
Carefully unpack your coffeemaker, removing all packaging materials, labels, and/or
stickers from your coffeemaker.
3.
Remove the plastic band around the power plug using scissors
4.
Clean your coffeemaker thoroughly before using for the first time. Wash the thermal
carafe and washable brew basket in warm, soapy water. Rinse and dry, then place
back into your coffeemaker.
5.
Clean the inside of your coffeemaker by running two full brewing cycles with water
only, no coffee.
a. Pour fresh, cold water into the water reservoir up to the 12-cup MAX
mark, then place carafe onto the carafe plate.
b. Plug cord into standard electrical outlet.
c. Push the ON-OFF / Power Button to immediately brew water through
the coffeemaker without adding coffee.
d. Once the cycle is finished, discard water.
e. Turn off appliance, unplug and allow to cool down for 15 minutes
before repeating.
P RO G R A M M I NG YOUR COF FEE M A KER
Setting the Digital Clock
1.
Plug the coffeemaker into a standard electrical outlet.
2.
The digital clock display flashes "12:00".
3.
To set the time, press the HR button until the correct hour appears on the
display. The "PM" symbol will appear in the upper right corner of the digital
display for PM time settings.
4.
Press the MIN button to select minutes.
Note: If the unit is unplugged or power interrupted, the time will need to
be reset, as will the Auto Brew delay start time.
Setting the Auto Brew Delay Start
The programmable Auto Brew delay start allows you to set the 24-hour timer
to brew coffee at the selected time, day or night. To activate the Auto Brew
timer, follow these steps
1.
After the digital clock is set, press the PROG button. The programmed
clock time will begin to flash.
2.
Press the HR button and then MIN button to select the time you would
like automatic brewing to begin (for example: 7:30 AM). Make sure the PM light
is not on, unless desired.
:
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières