Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NOTE: An Automatic charger automatically switches between Charge Mode and Maintain
Mode as necessary. The FULL CHARGE (green) LED will light up when the battery is
at full charge and off when the voltage drops below a preset level and the charger goes
into Charge Mode. This cycle will continue, and the FULL CHARGE (green) LED will
stay on for longer periods of time as the battery becomes more fully charged. This is not
applicable when in the manual charging mode.
NOTE: The Maintain Mode technology utilized in this charger allows you to safely charge
and maintain a healthy battery for extended periods of time. However, problems with the
battery, electrical problems in the vehicle, improper connections or other unanticipated
conditions could cause excessive current draws. Occasionally monitoring your battery and
the charging process is recommended.
Using the Engine Start feature
Your battery charger can be used to jump start your car if the battery is low. Follow these
instructions on how to use the ENGINE START feature.
Follow all safety instructions and precautions for charging your battery.
Wear complete eye protection and clothing protection. Charge your battery in a well-
ventilated area.
Using the ENGINE START feature WITHOUT a battery installed in the
vehicle could cause damage to the vehicle's electrical system.
1. With the charger unplugged from the AC outlet, connect the charger to the battery
following the instructions given in Section 6 (FOLLOW THESE STEPS WHEN THE
BATTERY IS INSTALLED IN A VEHICLE).
2. Plug the charger's AC power cord into the AC outlet following the precautions
described in Section 8.
3. With the charger plugged in and connected to the battery of the vehicle, set the
charge rate selector switch to the Engine Start position.
4. Crank the engine until it starts or 5 seconds pass. If the engine does not start, wait 4
minutes before cranking again. This allows the battery and the charger to cool down.
NOTE: During extremely cold weather, or if the battery is under 2 volts, charge the battery
for 5 minutes before cranking the engine.
5. If the engine fails to start, charge the battery for 5 more minutes before attempting to
crank the engine again.
6. After the engine starts, unplug the AC power cord and then disconnect the battery
clips from the vehicle.
7. Clean and store the charger in a dry location.
NOTE: If the engine does turn over but never starts, there is not a problem with the
starting system; there is a problem somewhere else with the vehicle. STOP cranking the
engine until the other problem has been diagnosed and corrected.
12. MAINTENANCE INSTRUCTIONS
12.1 After use and before performing maintenance, unplug and disconnect the battery charger
(see sections 6, 7 and 8).
12.2 Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clips,
cords, and the charger case.
12.3 Ensure that all of the charger components are in place and in good working condition,
including the plastic boots on the battery clips.
12.4 All other servicing should be performed by qualified service personnel.
13. MOVING AND STORAGE INSTRUCTIONS
13.1 Store the charger unplugged, in an upright position. The cord will still conduct electricity
until it is unplugged from the power outlet.
13.2 Store inside, in a cool, dry place (unless you're using an on-board Marine Charger).
13.3 Do not store the clips on the handle, clipped together, on or around metal, or clipped to cables.
13.4 If the charger is moved around the shop or transported to another location, take care to
avoid/prevent damage to the cords, clips and charger. Failure to do so could result in
personal injury or property damage.
All manuals and user guides at all-guides.com
7
•
•
Publicité
Table des Matières
