Loading The Rocker; Unloading The Rocker - Cole-Parmer 39457-00 Mode D'emploi

O
PERATION
Note
When using the rocker, the total
sample weight should not exceed
7 lbs (3.2 kg). Distribute the weight
evenly, balanced, and centered.
22
5. Install the rocker pivot ring: Line up the pivot
ring spline with the exposed socket then press
in and tighten the center fastener.
6. Set power switch on and set the rotisserie motor
switch on. Make sure the rocker functions prop-
erly with no interference.

Loading the Rocker

With the empty rocker in the incubator, load the samples
as follows:
1. Set the power switch on, set the rotisserie motor
switch off, and open the incubator door.
2. Install samples into the rocker. If you need to
move the rocker for easier loading, use the rotis-
serie motor switch to jog the rocker.
3. Close the incubator door, set the temperature,
and set the rotisserie motor switch on to start
processing.

Unloading the Rocker

Follow this procedure to unload the rocker:
1. Open the incubator door. Have power switched
on, and the rotisserie motor switched off.
2. Use the rotisserie motor switch to jog the rocker
if necessary to assist in removing samples.
3. Set the power switch off.
4. Clean the unit in preparation for the next use.