HIKOKI W 18DA Mode D'emploi page 8

English
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
NAMES OF PARTS (Fig. 1–Fig. 12)
Motor
Rotation selector
switch
Handle
Trigger switch
Hook
Battery
Dial
LED light
Switch panel
Remaining battery
indicator switch
(on tool body)
Remaining battery
indicator lamp
(on tool body)
Latch
Pilot lamp
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
W18DA / W18DB: Cordless Screw Driver
To reduce the risk of injury, user must read
instruction manual.
Stopper
Bit
Magnetic bit holder
Spindle
Closure sleeve
Screw
Groove
Stop sleeve
Setting sleeve
Union sleeve
Display panel
Remaining battery
indicator switch
(on battery)
Remaining battery
indicator lamp
(on battery)
8
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
Direct current
V Rated voltage
n
No-load speed
0
min Oscillation per minute
-1
Disconnect the battery
Switching ON
Switching OFF
Clockwise rotation
Counterclockwise rotation
Centre position: with the transporting safety
0
device engaged (switch-on lock)
Manual mode
Automatic mode
Impulse mode
Battery
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.