Scope Of Delivery; Warranty; Safety Devices; Appliance Description - Kärcher SC 1 Mode D'emploi

Scope of delivery

The scope of delivery for the appliance is shown on
the packaging. Check the contents for completeness
when unpacking. If any accessories are missing or in
the event of any shipping damage, please notify your
dealer.

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy pos-
sible malfunctions on your appliance within the war-
ranty period free of cost, provided that a material or
manufacturing defect is the cause. In a warranty case,
please contact your dealer (with the purchase receipt)
or the next authorised customer service site.
(See overleaf for the address)

Safety devices

CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Symbols on the appliance
(according to type of appliance)
Risk of burns, surface of appliance be-
comes hot during operation
Risk of scalding from steam
Read operating instructions
Safety lock
The safety lock seals the steam boiler from the steam
pressure present. If the pressure regulator is defective
and overpressure occurs in the steam boiler, an pres-
sure relief valve opens in the safety lock and steam
leaks out through the lock.
Prior to restarting the appliance, contact the responsi-
ble KÄRCHER Customer Service.

Appliance description

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery
(see packaging).
For the figures, please refer to the graphics page.
Illustration A
Safety lock
1
Filling hole for water
2
Switch
3
Child lock
4
Carrying handle
5
Grid connection cable with mains plug
6
Indicator light (green) - grid voltage present
7
Steam boiler
8
Steam nozzle
9
Unlocking button
10
** Steam hose
11
18
Steam gun
12
Unlocking button
13
Steam connector
14
Spotlight nozzle
15
Round brush
16
Power nozzle
17
Manual nozzle
18
Manual nozzle microfibre cover
19
** Manual nozzle microfibre cover (2 x)
20
** Extension tubes (2 pcs)
21
Unlocking button
22
** Floor nozzle
23
Hook and loop fastener
24
** Micro fibre cloth
25
Measuring jug
26
** Optional
During initial start-up, a small cloud of smoke may be
emitted from the steam nozzle. The appliance re-
quires a short run-in time. At the start, the steam out-
put is very irregular and damp, single droplets of water
may even leak out. The steam volume that leaks out
increases constantly until the maximum quantity has
been reached after approx. 1 minute.
Installing accessories
1. Push the open end of the accessory onto the
steam nozzle or steam gun until the unlocking but-
ton of the steam nozzle or steam gun engages.
Illustration F
Illustration I
Illustration J
2. Push the open end of the accessory onto the spot-
light nozzle.
Illustration K
3. Connect the connection pipes with the steam noz-
zle or steam gun.
a Push the 1st extension tube onto the steam
nozzle or steam gun until the unlocking button
of the steam nozzle or steam gun engages.
The connection pipe is connected.
b Push the 2nd extension tube onto the
1st extension tube.
The connection pipes are connected.
Illustration N
4. Push the accessory and/or the floor nozzle onto
the free end of the extension tube.
Illustration O
The accessory is connected.
Disconnecting accessories
1. Push the child lock down.
Illustration G
The switch is locked.
2. Push the unlocking button and pull the parts apart.
Illustration L
Illustration M
English

Initial Start-Up

Installation