Tripp-Lite SmartPro Manuel Du Propriétaire page 9

200503166 93-2406 Sinewave SmartPro Rackmount UPS OM.qxd
Basic Operation
Other UPS Features (Rear Panel)
AC Receptacles: Your UPS features 15-amp AC outlets, and select models also
feature 20-amp and 30- amp AC outlets. These output receptacles provide your
connected equipment with AC line power during normal operation and battery
power during blackouts and brownouts. The UPS protects equipment connect-
ed to these receptacles against damaging surges and line noise. If you have a
serial or USB connection to your UPS, you can remotely reboot connected equip-
15 amp/120V
ment by turning the receptacles OFF and ON using Tripp Lite's PowerAlert
NEMA 5-15R
Software. Select models have their receptacles divided into one or more load
banks (labelled "LOAD 1," etc.) which may be remotely switched OFF and ON
using Tripp Lite UPS software without interrupting power to equipment con-
nected to the other outlets. Select models feature special outlets (clearly labeled
on the rear panel) which provide surge-only (not battery backup) protection
designed for laser printers and other heavy-draw devices. Select models also
feature outlets labelled "UNSWITCHED", which may not be remotely
switched off. See software instructions for details.
20 amp/120V
NEMA 5-20R
20 amp/120V
30 amp/120V
NEMA L5-30R NEMA L5-20R
Communications Ports (USB or RS-232): These ports connect your UPS to any
workstation or server. Use with Tripp Lite's PowerAlert Software and included
cables to enable your computer to automatically save open files and shut down
equipment during a blackout. Also use PowerAlert Software to monitor a wide
variety of AC line power and UPS operating conditions. Consult your
PowerAlert Software manual or contact Tripp Lite Customer Support for more
information. See "USB and RS-232 Serial Communications" in the "Optional
Installation" section for installation instructions.
EPO (Emergency Power Off) Port: Your UPS features a EPO port that may
be used to connect the UPS to a contact closure switch to enable emergency
inverter shutdown. See Optional Installation.
continued
9
3/29/2005 3:12 PM Page 9