Unpacking And Assembly; To Install The Battery - Ardisam ION 11733 Manuel De L'opérateur

UNPACKING AND ASSEMBLY

TO ASSEMBLE THE AUGER TO THE POWERHEAD
1. Remove the allen wrench that is attached to the auger shaft
near the top with tape.
2. Insert the allen wrench into the bolt at the top of the auger
and remove by turning counter-clockwise.
3. Remove the protective plastic cap from the drive shaft. In-
sert the drive shaft of the powerhead into the collar of the
auger assembly. SEE FIGURE 1
4. Align the hole in the auger shaft with the hole in the
powerhead shaft. Tighten firmly, turning clockwise. There
may be some wiggle in the connection; this is normal. If the
connection is too tight, disassembly may be difficult.
TO CHARGE THE BATTERY FOR FIRST USE
1. Connect the charger to standard 110 or 240-volt outlet; a red
light should appear on the charger. Always connect charger
to standard 110 or 240-volt wall outlet before inserting
battery. SEE FIGURE 2
2. Charge the battery until the light on the charger turns solid
green.
3. To disconnect the battery, remove the plug from the wall
outlet then disconnect the battery from charger.
NOTE: Do not leave the battery on the charger after the
charge is complete. Unplug the charger from the wall and
remove the battery.

TO INSTALL THE BATTERY

1. Slide the battery onto the powerhead until it is fully seated.
2. Pull the rubber hold-down strap over the battery to keep the
battery securely on the powerhead.
NOTE: This cannot be done before the battery is installed.
The battery must be inserted onto the powerhead before
placing the strap over it.
6
BATTERY MUST BE FULLY CHARGED PRIOR TO FIRST
USE.
FIGURE 1
FIGURE 2
Check for parts online at www.ioniceaugers.com or call 800-345-6007 M-F 8-5 CT
IMPORTANT
allen wrench
bolt
Operator's Manual
ION® Electric Ice Auger
powerhead
drive shaft
protective cap
auger
110/240
volt outlet
MAYBE SHOW CORD
SAY TO PLUG INTO 12