Operating Modes; Displays - Sentiotec K2-NEXT Instructions D'installation Et D'utilisation

Figure 4
1

Operating modes

You can start the sauna control directly via the Quick-
Start feature (refer to chapter 6) or after the set desired
time has elapsed - time until the stove turns on (refer
to chapter 7).
2

Displays

Self-testing of the control
(display flashes).
Heater is running.
Heater is not running.
Door of the sauna cabin is open.
(applies to optional sauna door
safety-monitor only).
WE DO IT FIRST.
Instructions for use for the user
3 Optional sauna door
safety-monitor
To offer protection from fire hazards, the sauna door
will be monitored after the desired start-time has been
set (time until the stove turns on).
To prevent somebody from entering the cabin after the
desired start-time has been set, and perhaps place
an object on top of the stove, the control has been
equipped with a safety shutdown, which will respond
according to the operational status:
3.1 Operational status -
stove does not heat
The desired start-up time has been set. Heater is
not running yet. The sauna door is opened:
• You will hear a repeated beeping sound,
• the display 2 will indicate the message "door",
• the desired start-time will be cancelled.
After closing the sauna door, you will have to re-
enter the desired start-time.
3.2 Operational status - stove is heating
The desired start-up time has elapsed. The heater
is running. The sauna door is opened:
1. The temperature is below 40°C:
• You will hear a repeated beeping sound,
• the display 2 will indicate the message "door",
After closing the sauna door, you will have to re-
enter the desired start-time or you will have to
restart the control.
2. The temperature is above 40°C:
If you quickly open the sauna door (for less than 5
seconds) no message will be indicated. If the sauna
door is opened for longer than 5 seconds:
• you will hear a repeated beeping sound,
• the signal lamp 1 will flash,
• the heater will be turned off,
• the display 2 will indicate the message "door",
After closing the sauna door, the heater will be
turned on again.
• the beeping stops,
• the displayed message "door" disappears.
P. 7/14
EN