Publicité
Les langues disponibles
Les langues disponibles
EN: Mounting ESM knife bar
G90900102
Dokument: G90950115
Centre the drive levers A and the
hinge pins of the knives B on top of
each other. Insert hing pins of the
cutter bars into the drive levers.
Apply sufficient grease to the
driving pin of the upper cutter bar.
Reinstall the lower cutter bar. Put
the upper cutter bar in place and
spacer 0.3 - 0.5 mm
place a
between the lower knife and the
knife support.
Page 9
Lower the upper guide levers again.
Make sure that the driving pins
engage correctly.
Loosely attach the two M12 x 60
clamping screws with washers to
the hinge pin.
Attention: Make sure that the holes
of the hinge pins are positioned
above the axis of the hinge pin!
See page 8!
Apply light pressure by hand to the
two middle blades of the upper
cutter bar.
www.as-motor.de
Publicité
