Publicité
Les langues disponibles
Les langues disponibles
EN: Mounting ESM knife bar
G90900102
Dokument: G90950115
Apply light pressure by hand to the
two middle blades of the upper
cutter bar and tighten the
clamping screws on the hinge bolt
to 86 Nm.
Remove the spacer.
Grease the grease nipple.
Grease the grease nipple.
Page 10
Grease the grease nipple.
Grease the grease nipple.
Insert the adapter of the 3-claw
coupling.
Attention:
Do not lose when ESM cutter bar
is not attached to AS 600!
www.as-motor.de
Publicité
