Publicité
Les langues disponibles
Les langues disponibles
EN: Mounting ESM knife bar
G90900102
Dokument: G90950115
Both cutter-bars removed.
Place a square timber under the
mower drive.
Secure the bar to the base plate of
the drive with the four cylinder head
screws.
Seite 8
Tighten the four cylinder head
screws M12 x 1.5 x 20 (fine thread)
to 90 Nm.
Apply sufficient grease to the
driving pin of the lower cutter bar
re-attach the lower cutter-bar.
Make sure that the driving pins
engage correctly.
Make sure that the holes of the
hinge pins are positioned above
the axis of the hinge pin!
www.as-motor.de
Publicité
