Side Handle - DeWalt DW501 Guide D'utilisation

• Wear ear protectors when hammering for extented periods
of time. Temporary hearing loss or serious ear drum damage
may result from high sound levels generated by hammer drilling.
• Always use the side handle supplied with the tool. Keep a
firm grip on the tool at all times. Do not attempt to operate this
tool without holding it with both hands.
• Do not overreach while operating the tool. Maintain a
balanced working stance at all times. When necessary, use only
properly postioned, safe, platforms and scaffolding. WORK
SAFE.
• Hammer bits and tools get hot during operation. Wear gloves
when touching them.
• CAUTION:DO NOT TOUCH ANY METAL PARTS OF THE
TOOL when drilling or driving into walls, floors or wherever
live electrical wires may be encountered! Hold the tool only by
insulated grasping surfaces to prevent electric shock if you drill or
drive into a live wire.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
FIGURE 1
CAUTION: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this product
may contribute to hearing loss.
The label on your tool may include the following symbols.
•
V ........................volts
A ........................amperes
Hz ........................hertz
W ........................watts
min ........................minutes
........................alternating current
........................direct current
n o
........................no load speed
........................Class II Construction
.../min ......................revolutions or reciprocation per minute
BPM ........................beats per minute

Side Handle

CAUTION: Always use side handle when provided and hold
hammerdrill with both hands.
A side handle is supplied with this hammerdrill. It clamps to the front
of the gear case as shown in Figure 1 and can be rotated 360˚ to
permit right or left hand use.
3